| 39 CABLE INSTALLATION GUIDE RailFX® LOW PROFILE CABLE KIT INSTALLATION INSTRUCTIONS 1. Install the tensioning end first with the 2-3/8" long receiver. 2. Slip the Delrin washer over the body of the receiver and insert the receiver into the post. 3. Start the threaded stud attached to the cable into the receiver and turn 3 complete turns. This will thread about half the stud into the receiver. 4. Run the bare end of the cable through all your intermediate posts and through the end post where the pull-lock fitting will be installed. 5. Slip the Delrin washer over the body of the pull-lock fitting prior to running cable through fitting. 6. Push the cable into the hole in front of the pull-lock fitting. Twist the cable in the right-hand direction as it is being pushed. If the cable begins to “unravel” it is being rotated the wrong way. Push the cable until it is through the fitting. 7. Once the cable is through the fitting, pull cable while holding the pull-lock fitting firmly in the hole on the post. Hold the fitting in one hand while pulling the cable through as tightly as possible. NOTE: Longer runs of cable and cables that go around corners may need to be pretensioned. Low Profile Kit Contents Pull-Lock® Fitting with cap 1/8" 1x19 stainless steel cable Pre-attached swaging stud Invisiware® Receiver Delrin® washers for use with metal posts Stainless Steel washers for use with wood posts NOTE: Parts must be kept clean and free of debris before installation for best results.
RkJQdWJsaXNoZXIy MzU1MDAz