STEP 1: Update Step 1 to read: Drill posts for cable and fittings using the RailFX Universal Post Drilling Template. For 36" rail heights, cut 8" off one end of drilling template to fit the posts. If not using the drilling template, use a tape measure and mark 3-1/8" from bottom of top rail to first hole. (Note: cable spacing is 3-1/8"). END POSTS: • Using RFX Universal Drilling Template, clamp the template to the inside face of each end post, aligning the top side of the template to the underside of the top rail and center the template to the post. • Using a 1/8" drill bit, drill approximately 1/4" into the post. This will mark where each fitting will be attached to the post with the supplied 2-1/2" screw. • Using a T25 bit, attach Flex Mounting Cups (FF-MC-W) to the post using the supplied 2-1/2" Stainless Steel Screw or longer screws (sold separately) for sleeved posts. It may be necessary to pre-drill before the mounting bases are installed if screws are being installed into a hard wood. 42 |
RkJQdWJsaXNoZXIy MzU1MDAz