• Attach all non-tensioning and tensioning hardware to the mounting bases. (Note: Make sure all tensioning fittings are adjusted to the same location - ensuring enough thread turns remain for final tensioning of the cables). ASSEMBLING ASSEMBLED STEP 2: DRILL INTERMEDIATE POSTS • Each intermediate post will need to be drilled all the way through so the cable can pass through to the next intermediate post or end post. Center and clamp Universal Post Drilling Template to one side of the intermediate post. Mark hole locations with pen or marker for each hole in the template. Then move the template to the other side of the post and repeat this process for all intermediate posts. • Remove template and, using a 7/32" drill bit, drill halfway through posts for all holes on each side of post. NOTE: If cable is transitioning out of the post at an angle, use RFX Post Protector Tubes (4903061). Holes in post must be 1/4" diameter for installation of 3061. | 43
RkJQdWJsaXNoZXIy MzU1MDAz