• Go to the other end of the cable and pull cable tight and align cable with cut mark on the tensioning end fitting. Mark cable and cut with RFX cable cutters (3068). • Push cable into the Tensioning fitting by pushing cable into fitting while rotating cable in a clockwise direction. After insertion, stop rotating cable and push in. This will keep the cable from unraveling. Repeat this process for each run of cable. • Tension cable using the wrenches in the RFX installation kit. Tension all cables to specified tension of 225 lbs., beginning with the center cables, moving up and down toward the top and bottom. As you tension each cable, give it a sharp pull downward mid-span to help set the wedges, then re-tension as necessary in the same sequence. Be aware that the cable may move as much as 3/16" toward the tensioning terminal as the wedges seat. 45|
RkJQdWJsaXNoZXIy MzU1MDAz